Safe to swap connectors on Li-Po batteries?

[Philbruh]

So i bought a couple of batteries from hobbyking and didn't realise that they had xt-30 connectors. This doesn't suit my current build which has an xt-60 connector on the power lead.

I have a few spare xt-60 connectors lying around, would it be safe to swap these over on the xt-30 batteries?

The wire gauge on the battery with the xt-30 connector is a bit smaller in comparison to another battery which has an xt-60 connector (a couple of millimeters if anything), so i'm not sure if this will be an issue in terms of current/ voltage output to the PDB??

 

[dragger201]

It should be fine. But a word of caution..........only do one wire at a time.........keeps from shorting out the battery.........

 

[mozquito1]

Cut the ground prepare it then solder onto new connector. Then cut the positive & do that. But do put any heat shrink on first.