Omnibus f4 nano v6

[hemanthksethuraman@gmail.]

I recently bought a omnibus f4 nano v6 FC. I however have 4 separate esc and the FC only has input for 4in1 esc. I am using a dji f450 frame which has a pdb and pads for the 4 escs. Is there a way I could connect the esc to my fc through the frame so I don't have to buy another esc. I would appreciate your suggestions.

 

[Launchpad]

You can use individual ESCs, but not through the frame. You'll just need to connect the signal wire from the ESC to the correct pad on the board, or splice them the ones on the harness.

Original Airbot Omnibus F4 Nano V6.1 Flight Controller OSD 5V 2A BEC LC Filter 2-6S 20x20mm

Only US$44.99. Get the Original Airbot Omnibus F4 Nano V6.1 Flight Controller with OSD, 5V 2A BEC, LC Filter, and support for 2-6S batteries. Perfect for your drone projects.

www.banggood.com

 

[Dugdog47]

You can hook the battery to the frame, power the escs from the frame then either solder the signal wires into the fc or make a harness that plugs your signal wires into your fc.

On a side note, I did something similar and it worked fine until I drilled some holes through the frame to mount a fpv camera which caused the battery to short out lol. Don't drill holes in your frame if you've got it powered up.

 

[hemanthksethuraman@gmail.]

Thank you very much guys. Also one more question on the RSSI, is it only possible to connect the RSSI from receiver if the FC has a dedicated RSSI location or could I solder it to any Tx pad and expect it to work?