My quadcopter becomes unresponsive when I disconnect the Naze32 from my compter

[Daniel Roberson]

Help! This is my first quadcopter build and I am having an issue where I unplug the usb cable from my Naze32 rev6 (I am using cleanflight) and when I try to do anything on my transmitter, nothing happens. There is just a solid blue light. I have been trying to get this thing to work for three days now, but no luck. Any help would be much appreciated

 

[RENOV8R]

Try flashing the firmware

 

[Daniel Roberson]

Yes, I have already flashed it multiple times and did the full erase.

 

[Jackson]

when I try to do anything on my transmitter, nothing happens.

What is this mystery TX and RX?

 

[Daniel Roberson]

Tunigy 9x

 

[Jackson]

quadcopter becomes unresponsive when I disconnect the Naze32 from my compter

So that means while connected to the computer it is responsive?

 

[Daniel Roberson]

Yes, i can control it when it is plugged in(with my radio)

 

[RENOV8R]

Do the motors spin up in motor test tab? Have you correctly calibrated gyro and mag? If so, it sounds like it's just not arming. What stick movements are you doing to try and arm it?

 

[Daniel Roberson]

The motors are calibrated and spin in unison. I have the arm switch connected to the aux1 on my radio. The gyro and accelerameter are calibrated aswell. I can arm and control ny quad while it is connected to my computer, but when I unplug it i can not do anything.

 

[RENOV8R]

Just curious. Even though you've got a switch set up to arm, move your throttle stick to the bottom right corner and see if that works

 

[Jackson]

How are you powering the Naze?

 

[Daniel Roberson]

It does not work using the control stick to arm. I am powering my naze with a 3s lipo

 

[Quest]

Is your lipo good? Have you checked its voltage?

 

[Daniel Roberson]

Its good because i can make the motors spin when it is plugged in to my computer

 

[Quest]

Have you actually checked the lipo voltage with a meter? If not you should.

 

[Altsickeness]

It does not work using the control stick to arm. I am powering my naze with a 3s lipo

So 5vts from bec or pdb? And your rx is powered on? jacksons after your power. When you power by usb it works. without usb hooked up it doesnt. Thats were you should look. What is the usb doing to the naze that your battery power alone is not doing?

 

[Altsickeness]

Help! This is my first quadcopter build and I am having an issue where I unplug the usb cable from my Naze32 rev6 (I am using cleanflight) and when I try to do anything on my transmitter, nothing happens. There is just a solid blue light. I have been trying to get this thing to work for three days now, but no luck. Any help would be much appreciated

Wait so a blue light on naze or on rx?

 

[Daniel Roberson]

On the naze

 

[Altsickeness]

On the naze

You set up ppm or pwm? And you have 5 vts to naze and rx?

 

[Daniel Roberson]

I have pwm. 5vts?