RENOV8R
Well-Known Member
I've been flying my little puddle jumpers for a while now and comfortable with basic manouvers and can magage to run through a battery or 2 without crashing, so it's time for my first build.
Have a ZMR H250 kit on the slow boat from China (I"ve taken the advise from this forum and have ordered an AbuseMark Naze 32 Rev 6 to replace the crappy CC3D) and have also ordered this PDB
http://www.amainhobbies.com/rc-dron...-w-5v-12v-bec-led-strip-diab3010601-1/p454443
Has anyone had any experience with this? Like the idea of less wires and a cleaner look to the build but I'm just leary of the fact that it has power running through it. As CF is conductive, is this whole board live? I'm going to isolate it with nylon standoffs, I'm just worried that if I attach anything onto it like an FPV camera that I'm going to fry the whole thing. Are there any extra precautions I should be taking or is this one of those products that I should not be using?
Have a ZMR H250 kit on the slow boat from China (I"ve taken the advise from this forum and have ordered an AbuseMark Naze 32 Rev 6 to replace the crappy CC3D) and have also ordered this PDB
http://www.amainhobbies.com/rc-dron...-w-5v-12v-bec-led-strip-diab3010601-1/p454443
Has anyone had any experience with this? Like the idea of less wires and a cleaner look to the build but I'm just leary of the fact that it has power running through it. As CF is conductive, is this whole board live? I'm going to isolate it with nylon standoffs, I'm just worried that if I attach anything onto it like an FPV camera that I'm going to fry the whole thing. Are there any extra precautions I should be taking or is this one of those products that I should not be using?