Search results

  1. K

    Pixhawk on Geprc LC7HD frame

    As topic quoted, does pixhawk flight controller (liked 2.48 and latest 6c) could be fit inside Geprc 7 inhces HD frame along with skyroid receiver? Thanks.
  2. K

    Difficult to fly in pilot sight of view or FPV

    There is no problem to fly in LOS (Line of Sight) but It is totally difficult to fly in Pilot sight of view aka FPV and I always ended to flip over on first until three seconds. I'd attached a picture and what is it called from those highlighted in red circle (watermark?), does it help to...
  3. K

    Aux 5 not working on betaflight

    I'd tried to create GPS recues Mode on Radio's (AUX 10) with Betaflight (AUX 5), but It won't work. Betaflight seems to be support until channel 4 (AUX 4) and not more. Below is my Input & Mixer againts betaflight ( Working ) Arm (Radio - AUX 5) - AUX 1 (Betaflight) Turtle Mode (Radio - Aux...
  4. K

    How to fly like a PRO

    I'm experienced difficult to fly in real life instead of gaming in simulation (There is no problem to fly in liftoff for me). I'd no idea to fly in step forward by holding pitch after weared in FPV googles even without wearing fpv googles. My quad just always hover to the left and ended up to...
  5. K

    FPV google display black screen after play a while without power on

    Does i need to "power on" fpv google before quad? It seems to be black screen from google after I play a while on my 5 inches drone without google before I plug the power to turn on the fpv google. It just showing RSSI 99 % and battery voltage level only. Why? FYI, I'm using AKK FX2...
  6. K

    Does my prop setup in properly?

    As per topic, I suspect my prop setup could have wrong directional setup I'm using prop out (reversed directional). It just spin out vertically 360 degree and drop into ground. Then my telemetry lost to my controller. why?
  7. K

    How to wire and bind redundancy (fport)

    Hi, all. I'd both Frysky R9 slim plus OTA with the following build with FPORT connection (Inverted) (Master) smartport - TX1 (FC) VCC - 5 volt (FC) GND - GND (FC) SBUS IN - SBUS OUT(SLAVE) (SLAVE) SBUS OUT - SBUS IN(Master) VCC - 5 volt (FC) GND - GND (FC) Is this correct? Master receiver is...
  8. K

    Lowest RSSI value in configuration setup and google

    I've recently bind my both R9 slim + OTA receiver on my quad, one for Telemetry ON and one for Telemetry OFF (Redundancy built). In CLI, I do make liked this, set serialrx_halfduplex = OFF set serialrx_inverted = OFF get tlm set tlm_halfduplex = OFF set rssi_scale = 200 T18 Jumper...
  9. K

    Problem to wires OSD and VSen, what is IO1 & IO2

    Problem Where to solder : Foxeer Falkor Mini 2 OSD and VSEN - (Where can i connect the OSD) I still have last empty TX3 & RX3 for use, does it able for to direct connect Foxeer OSD pin into TX3? VTX transmitter - SmartAudio to TX4 (Correct? or RX4). Another question still hanging on me...
Top