Jeremy C. Hansen
New Member
Hello,
I'm not certain this is the proper place for it but I'm having an issue with my Zenmuse H3-2D Gimbal attached to DJI Phantom. I had it working perfectly for a few months until I had a bit of a rough landing while flying it in Paris. It didn't actually land since I caught it mid air before it hit the ground, but the force was strong enough to unsolder a ground wire. After re-soldering the wire, the Zenmuse is getting power indicated by the red light in the back but the motors are not powering up. I've checked all of the connections undid them and reconnected them to no avail. Any suggestions would be GREATLY appreciated.
Thank you!
- J
I'm not certain this is the proper place for it but I'm having an issue with my Zenmuse H3-2D Gimbal attached to DJI Phantom. I had it working perfectly for a few months until I had a bit of a rough landing while flying it in Paris. It didn't actually land since I caught it mid air before it hit the ground, but the force was strong enough to unsolder a ground wire. After re-soldering the wire, the Zenmuse is getting power indicated by the red light in the back but the motors are not powering up. I've checked all of the connections undid them and reconnected them to no avail. Any suggestions would be GREATLY appreciated.
Thank you!
- J