Charlie R Chisholm
Member
I just received my new Phantom 1.1.1. I got it all put together, charged the batteries and did the calibration of the compass. The copter flashes a slow green that I assume means all is well, but there I am stuck. I have seen no activity from any of the motors yet and don't know how to start that process. I know the transmitter and the copter are communicating on some level because if I turn it off the copter complains with a rapidly flashing yellow light. Turn the tx back on and the slow green flash resumes. I have tried just about every combination of the two 3-position switches, but the only thing that ever changes when I move the sicks is that the green light will flash twice pause and repeat while I hold the stick down. Can anybody help me figure out where I go from here???
I tried to use the Naza -m V2 assistent software but it says no transmitter installed and I can't figure out how to make it see my transmitter. If I click the test motors, I get a message saying to connect to the controller. Not a clue what to do about that. The USB is in place.
Thank you in advance for any help you can give.
I tried to use the Naza -m V2 assistent software but it says no transmitter installed and I can't figure out how to make it see my transmitter. If I click the test motors, I get a message saying to connect to the controller. Not a clue what to do about that. The USB is in place.
Thank you in advance for any help you can give.