Sam Clare
Member
I am new to RC and have built a quadcopter using a x650f, 30a Plush escs, NM 800kv motors, fat shark pred v2 and 300mah batteries.
I have built the quad having done hours and hours of research and am convinced it is built and wired correctly.
Whenever I hold buttons 1 and 4 on the KK2.1, plug in and push the throttle up it doesn't calibrate the quad and I can't arm it to sort out the motors.
I have spent the last few hours banging my head against a brick wall trying to work it out. I have watch video after video and page after page to no avail.
I am using a converted (Mode 1 to 2) Turnigy 9x with the throttle reversed.
Like I said I am a RC virgin and its probably something silly I am not doing right.
Any help and advice would be greatly appreciated.
I have built the quad having done hours and hours of research and am convinced it is built and wired correctly.
Whenever I hold buttons 1 and 4 on the KK2.1, plug in and push the throttle up it doesn't calibrate the quad and I can't arm it to sort out the motors.
I have spent the last few hours banging my head against a brick wall trying to work it out. I have watch video after video and page after page to no avail.
I am using a converted (Mode 1 to 2) Turnigy 9x with the throttle reversed.
Like I said I am a RC virgin and its probably something silly I am not doing right.
Any help and advice would be greatly appreciated.
