Insane Drone Lift Off

Discussion in 'Flight Videos' started by DrAbsurd, Feb 12, 2018 at 1:08 AM.

  1. DrAbsurd

    DrAbsurd Well-Known Member

    What the what did I just see?
     
    ArmyVet, KentA and Spork like this.
  2. DrAbsurd

    DrAbsurd Well-Known Member

    Had to rig up my spring switch to turn my air mode off and on. Air mode caused crazy bouncing. I have to hold that switch up whenever im on the ground skidding.
     
  3. Spork

    Spork Well-Known Member

    Look like fun. With that small gap, I figured it was only a matter of time to see quad and car contact - glad to see it looks unscathed. Might be a good way to clean mud/etc from underneath your vehicle. :D
     
    DrAbsurd likes this.
  4. DrAbsurd

    DrAbsurd Well-Known Member

    only broke the tip off a blade. Its an expensive cleaning system, for sure.
     
    Spork likes this.
  5. mozquito1

    mozquito1 Well-Known Member

    You may need to dremmel them bolts off soon. Get some raised bolt covers.
    Nut_Covers_New-1024x1024.jpg
     
  6. DrAbsurd

    DrAbsurd Well-Known Member

    The way I have it rigged up all my screws that could hit the ground are covered. So far I havent seen any new scratches at all under the quad. I dinged up the camera mount frame mount screws the day I got it but they still look exactly the same. I added middle skids to stop the frame from flexing and bouncing. All the skids have pads to take some of the shock.
     
  7. mozquito1

    mozquito1 Well-Known Member

    I don't mean the (floor) ground.
    You should use either rubber pegs or plastic standoffs.
    So nothing short circuits...
     

Share This Page