How to set up PPM

[Terryfrank84]

Hi guys, so I've got a 250 quadcopter, and I need to change my setup to enable ppm. I've got a orange 615x rx and a futaba ff9 tx spektrum 2.4 gig module.
Running on a full naze32 board. Thanks in advance for help

 

[GJH105775]

Check page 10 in this manual.
http://www.abusemark.com/downloads/naze32_rev3.pdf


If you already know how to get to the terminal then:


WARNING
Any changes to settings in cli, in particular related to motor output (throttle
values, etc) are accepted REALTIME and may result in motors starting up without warning.
Always configure with props disconnected or when model is only powered by USB.
Common usage examples:

To enable CPPM receiver, enable PPM feature:
# feature ppm
# save

 

[Terryfrank84]

Cheers for the fast response, I'll look into this now

 

[GJH105775]

I try to keep them nice and quick .