Help With Spektrum Dx6i Please...

[Glenn]

Hey Guys,

Can anyone please tell me where the parameters outlined on the attached image (outlined in red for my flight controller) are set-up on my Spektrum Dx6i? Not sure what I need to change on the Spektrum.

Thank you, Glenn

 

[RENOV8R]

Check YouTube, there's a million videos to explain how to set up your Dx6i

 

[Glenn]

I checked YouTube, but it seems that the videos are very model specific. The quad I have is a 250 build and the flight controller stated the values in the picture. I just don't know where those values should be input into the Spektrum. I assume they state these values for optimum performance. I am obviously a newbie and want to put values in that make it as easy to fly as possible, not full on race or aerobatics! This quad is probably a bit to much for me, but hoping to make the best of it!

Glenn

 

[RENOV8R]

OK I know you're new and all but really, if you can't figure this out then goo luck actually programming your 250. You've got a LOT of research to do.So, as for your radio:

Main screen: select model type and switch to airplane (doesn't make sense but that's how it is).

As for the parameters shown, forget it. Set travel for all channels to 100%, subtrim to 0. You'll do most of your fine tuning in the software.

 

[Glenn]

Thank you.

 

[RENOV8R]

Not a problem, any questions just ask. There is a good video I have somewhere that'll better explain your radio & setup, I'll try to find it when I get home from work. Also, you can do a Youtube search for OrangeRX T-6, it's exactly the same radio as the Dx6i. Any idea yet what software you're going to use to set your quad up?

 

[Glenn]

According to the flight board supplier the board has been pre-programmed and should fly right out of the box. At this point I probably wouldn't want to horse around with it until I try it out. My needs are very basic. If I run into issues at that time I'll have a look at changing defaults on the board. The only suggestions they made are the one's printed on the outside of the package as I have shown. Is there software you would suggest?

Glenn