So I just got my KingKong 90gt in and I got it all setup and flashed with new firmware and bound to my radio.
As I'm putting the props on this little guy (they are extremey tight on the shaft) the force from just pushing the prop on pushed the shaft downward through the motor.
I was able to push it back up to where it seems to be even with the other motors but I'm curious as to why this happened and if it damaged anything by doing so.
The motors are Kingkong 1103 7800kv brushless.
What can I do to prevent this from happening in the future or if I did damage something is it fixable?
Any help is appreciated!
As I'm putting the props on this little guy (they are extremey tight on the shaft) the force from just pushing the prop on pushed the shaft downward through the motor.
I was able to push it back up to where it seems to be even with the other motors but I'm curious as to why this happened and if it damaged anything by doing so.
The motors are Kingkong 1103 7800kv brushless.
What can I do to prevent this from happening in the future or if I did damage something is it fixable?
Any help is appreciated!