YEAAAABOOIIII
Member
Hello all,
I recently purchased my first build kit - the Roto Riot Racer DIY Kit (https://rotorriot.com/collections/build-your-own-fpv-drone/products/rotor-riot-race-build-diy-kit).
After asking for instructions I did not receive them. Im trying to use the included ports to make a cable from "HGLRC Dinoshot 40a 4in1 ESC" to the "T-motor FC F4"
ESC to Flight Controller connections:
Unknowns / Remaining
Thank you all.
I recently purchased my first build kit - the Roto Riot Racer DIY Kit (https://rotorriot.com/collections/build-your-own-fpv-drone/products/rotor-riot-race-build-diy-kit).
After asking for instructions I did not receive them. Im trying to use the included ports to make a cable from "HGLRC Dinoshot 40a 4in1 ESC" to the "T-motor FC F4"
ESC to Flight Controller connections:
CRNT to CNT (2nd from bottom)
S2 to 2
S4 to 4
S1 to 1
S3 to 3
- to -
BAT to +
Unknowns / Remaining
Remaining ports on ESC
- “TXD”
Remaining Ports on FC
- “-“
- NC
-RX4
Can anyone double check to make sure these are correct and where do these remaining ports go?Thank you all.