first build help!!

C

C4rd0z

Member
Ok so I’ve decided i want to get into the whole quad copter scene and want to start off. Don’t want to start off with one of these pre made kits and would much rather start off with something I’d built myself. I built my mates DJI f450 kit with little problems but I don’t really have the cash to splash on the DJI atm. I’ve found a airframe i like and order it. Need to decide on what motors, ECS’s and props to use now. below is what i propose to use. Any comments/advice would be much appreciated
Frame – Turnigy Talon V2 Quad copter frame (300g bare airframe)
Motor:-
Choice 1 - NTM Prop Drive Series 28-30A 800kv (short shaft version)
Choice 2 - NTM Prop Drive Series 2826 1000kv
ESC - Afro ESC 30Amp Multi-rotor Motor Speed Controller (SimonK Firmware)
Props – 10 x 4 SF
FC – KK2.0 HC
Battery – Mixtures ive been given all 3s. 3500, 2200, 4000 & another 3500
TX – Futaba T10CG 2.4
All I’ve left to buy are the motors and the ECS please advise me if I’ve chosen wisely
 
C

C4rd0z

Member
Link I say totally new to the hobby I just loved the luck on the frame didn't really look at anything else also looked cheap enough to replace if brakes. Everyone else seems to learn on for f450 fram which is small so didn't thinkmit would matter too much
 
You must log in or register to reply here.
Top