This is my first quadcopter project, and I'm having some problems with my hobbyking multi-rotor control board v3.0, I've already tested my radio with the esc's and everything works fine, but when I try to connect everything to the control board it doesn't work, the board makes some startup sound but the motors don't spin at all. I'd like to know if I need to upload anything to my control board, I thought it already came programmed.
This is my set up:
4 Props- 10x4.5 SF Props Black CW (2pc) CCW (pc)
4 -Qbrain 20A ESC's
4 - D2822/17 Brushless Outrunner 1100kv
1 HobbyKing 6ch 2.4ghz Transmitter and receiver (Mode 2)
1- HobbyKing Multi-Rotor Control Board V3.0 (Atmega 328 PA)
1 - Zippy 3000 mAh 3S Lipo Pack
Thanks
This is my set up:
4 Props- 10x4.5 SF Props Black CW (2pc) CCW (pc)
4 -Qbrain 20A ESC's
4 - D2822/17 Brushless Outrunner 1100kv
1 HobbyKing 6ch 2.4ghz Transmitter and receiver (Mode 2)
1- HobbyKing Multi-Rotor Control Board V3.0 (Atmega 328 PA)
1 - Zippy 3000 mAh 3S Lipo Pack
Thanks