DJI F450 and Turnigy 9X

[IndianMessi]

Hello everybody and thank you for taking the time to look at this post.

I finished my F450 build and I am using a Turnigy 9X. The problem is I have no idea what settings to use or where to connect each servo connector, etc. If this helps I am using a Naza-M Lite FCB.

Thanks for your time!
-IndianMessi

 

[holtneil]

Hi mate start at the transmitter set up as aero ( plane NO mixing ) just basic set up
The Receiver wires will plug into the naza
Rudder =R
Elev=E
Aile=A
Throttle=T
Now the motors
Motor 1=M1
Motor 2=M2
Motor 3=M3
Motor 4=M4
F1/F2 are for the camera gimbal F1=Roll F2=Pitch
thats it all done , here is the manual for the Naza M lite
http://download.dji-innovations.com/downloads/naza-m lite/en/NAZA-M LITE_User_Manual_v2.00_en.pdf

 

[IndianMessi]

OK, after all this will I need to change any settings in the Naza assistant.

 

[holtneil]

Your need to go into Naza assist and set up the FCB ( full set up ) this is so you know all all set right ready to fly , would be a shame to crash it on its maiden flight

 

[IndianMessi]

OK thanks!

 

[IndianMessi]

Hi after a fruitful maiden flight I have heard about Gains. I don't know what these are but I do know that they can make a quad fly much more differently. What gains should I use as a beginner?

 

[holtneil]

Hi mate its not what gains for a beginner, you have P&I gains on all axis but most link pitch and roll, Ok write down what the gains are right now ,so if you mess up you can put then back in , Put the I gain to zero on pitch or roll if linked it does not matter , adjust up the P gain till quad wobbles very fast your hear the motors twitter now lower till it stop its wobble ,Thats the P gain done
Now do the I gain turn it up till the quad starts to wobble ( but slowly this time) now turn down till this stops , Thats the I gain done
The quad should fly really well now if the axis is not linked then put the same setting on both axis as the one you adjusted but like I said most are linked any way
here is a video for the kk( i know you dont have this board but this will show you what your looking for )