Hi,i'm building my first quadcopter with arduino UNO, GY521 and a 9x8cv2 receiver like in this picture
http://www.mediafire.com/view/2ff69s7des7d6vs/spiegazione_quadricottero.png
But after connecting all it don't work! Motors do 3 beep and then 1 beep every second but they don't work. I think the problem is around the connections to the receiver, i'm following this datasheet:
CH1: PITCH
CH2: ROLL
CH3: THROTTLE
CH4: YAW
CH7: MODE
Can someone posts the correct datasheet for this receiver? or maybe tell me about the other possible problems that cause the not working of my quadcopter.
thank you guys,sorry for my english
Picture of my quadcopter connections:
https://drive.google.com/file/d/0B-ZJ-O4Z8d16bHhvMGdPeWdQWkU/view?usp=sharing
http://www.mediafire.com/view/2ff69s7des7d6vs/spiegazione_quadricottero.png
But after connecting all it don't work! Motors do 3 beep and then 1 beep every second but they don't work. I think the problem is around the connections to the receiver, i'm following this datasheet:
CH1: PITCH
CH2: ROLL
CH3: THROTTLE
CH4: YAW
CH7: MODE
Can someone posts the correct datasheet for this receiver? or maybe tell me about the other possible problems that cause the not working of my quadcopter.
thank you guys,sorry for my english
Picture of my quadcopter connections:
https://drive.google.com/file/d/0B-ZJ-O4Z8d16bHhvMGdPeWdQWkU/view?usp=sharing
Last edited: