Treyh267
Active Member
ok so I have had this 250qav in the air so a few seconds. my throttle was backwards but I believe I have fixed that.
now I have an issue my receiver(dx6i) does not seem to respond to my quad. I can manually set up my receiver on openpilot but the wizard will not work.
On the wizard, when it says to set my max it and min it dosent move on openpilot when I move my sticks.
when I manually set the max and min everything seems fine. Im thinking that's why it wont let my receiver arm or increase throttle whatsoever anymore.
UGG so i have all these questions if i knew this i think i could solve my problem and finally get my first quad up into the air!! Please and thankyou for any help your can give...!!
Why does my receiver manually calibrate but wont set max and min on the wizard?
Why wont my cc3d arm when i set it to yaw right or any other arming setting other then always armed?
Why wont my controls work even when i set my cc3d to always armed!!?
oh BTW i also did some checks i went into output and checked the box to spin motors when armed, and set to always armed = they spun....
so that means the motors work and the cc3d does arm and work.
the receiver wont respond to the quad and is bound i have a solid light. responds only on manual calibration on openpilot
now I have an issue my receiver(dx6i) does not seem to respond to my quad. I can manually set up my receiver on openpilot but the wizard will not work.
On the wizard, when it says to set my max it and min it dosent move on openpilot when I move my sticks.
when I manually set the max and min everything seems fine. Im thinking that's why it wont let my receiver arm or increase throttle whatsoever anymore.
UGG so i have all these questions if i knew this i think i could solve my problem and finally get my first quad up into the air!! Please and thankyou for any help your can give...!!
Why does my receiver manually calibrate but wont set max and min on the wizard?
Why wont my cc3d arm when i set it to yaw right or any other arming setting other then always armed?
Why wont my controls work even when i set my cc3d to always armed!!?
oh BTW i also did some checks i went into output and checked the box to spin motors when armed, and set to always armed = they spun....
so that means the motors work and the cc3d does arm and work.
the receiver wont respond to the quad and is bound i have a solid light. responds only on manual calibration on openpilot
Last edited: