marc512
Member
Hi there. I've not been having a lot of luck with any TX/RXs lately with my quadcopter. My first DX5e has just stopped working completely and my friends tunigy controller doesn't even want to bind to my quadcopter. I've taken the plunge and bought myself a brand new DX6. I followed the correct instructions to bind it. I put in the bind plug, inserted an ESC and plugged in my battery. I held down the bind button and turned on my transmitter. After a few seconds, It came up saying bind failed.
I was unsure if I needed to plug all the ESCS into the naze32 and insert the throttle from the board to the receiver then bind. So I tired that, bind failed after 5 seconds. I tried the normal bind plug plus receiver power pack and that bound just fine. Does anyone have any suggestions?
Thanks
Marc
I was unsure if I needed to plug all the ESCS into the naze32 and insert the throttle from the board to the receiver then bind. So I tired that, bind failed after 5 seconds. I tried the normal bind plug plus receiver power pack and that bound just fine. Does anyone have any suggestions?
Thanks
Marc