Can not get the receiver to work.

Discussion in 'First Build' started by Jacob Blocker, Dec 26, 2016.

  1. Jacob Blocker

    Jacob Blocker Member

  2. Jackson

    Jackson USA member at large

    What is that exactly? Post a link.
     
  3. Jacob Blocker

    Jacob Blocker Member

  4. holtneil

    holtneil Well-Known Member Moderator

    Hi mate make you the servo plug is the right way round signal wire is always the lightest colour of the 3 wires , and then this should be in the Channel 1 of the receiver
    there is also a software update for the transmitter
    make sure the transmitter is set to ppm too
     

Share This Page