pdb

Hi! I have an Matek F722 STD + FCHUB-6S setup where the FCHUB-6S is broken. FCHUB-6S are hard to get hold of these days. Is there a newer alternative I can use as effectievly with by Matek F722 STD which connected to the FCHUB-6S via the inlcuded flat cable. I know these are older boards, but...

I am building a quadrocopter and have almost all the components. I now need to buy a PDB to provide power to the ESCs / Motors. And I'm not sure what power rating / power specs I need in a PDB. When it comes to power requirements (e.g. volts, amps, watts) I know the basics, but just want to...

Hi, I have a few questions regarding my connections. I'm not 100% sure if I have done it correctly. :) I have already soldered it up, but I have made this illustration to make it clearer.. i hope. The components showed: PDB Diatone v8.3 FC Omnibus F3 FrSky XM+ 1. To take the easy thing...

Hi all! I'm new here on the forum so this is my first post. I'm building my first FPV drone at the moment. Even thou I have watched many build videos, I still have a lot of beginner questions I don't dare to ask elsewhere. I hope this newbie forum section can help me. :) Ok... I have 3...

Hey all, I have a Matek Systems PDB (Found Here), and I also own an Eachine FPV camera (Found Here) and an Eachine VTX (Found Here). The PDB has a 5V, 12V, and two Ground pads. What do I connect and where? Thanks in advance.

I'm choosing parts for my first build, and I like the Holybro Kakute F4. I'm confused about the product combination to buy. Should I get: Kakute F4 V2 AIO (holybro product/51) Comes with PDB, unlike the Kakute F4 V2 (holybro product/50) Tekko32 4-in-1 35A ESC (holybro product/54) One unit...

Hi, my drone's VTX is a TS832, and I also have an RC832 Reciever. I have Quanum v2 DIY goggles, and everything is wired correctly (camera and VTX are directly soldered to PDB). When I turn everything on, the goggles just display static and say "NO SIGNAL." I've been through all 40...

Hello everyone! So this is my first time building a quadcopter (and soldering too). I used a relatively old soldering gun to tin my wires and PDB and it went mostly well but when I plugged in my battery nothing happened and this part came off. I know I have to reattach it but I am not sure if my...

was interested in the the whole fpv thing and decided to get myself one, i went the easy route and bought an already built one. Ive been flying this one for a couple months already, its a decent quad for $100 but i ended up crashing it and breaking the PDB. so now im stuck with this broken quad...