arming issues

In my previous thread I asked for help because my quad was flipping off of take off. This turned out to be that the FCB was pointing the wrong way in the quad so I had to change the direction in betflight to point forward. Now the quad matches the betaflight diagram when I tilt and turn it but...

Greetings, recently I bought an Eachine Wizard X200S from Banggood. After I opened it, I had to replace the reciever cable to connect the drone with my Flysky i6, but it wasn't a problem. I paired the drone with the controller successfully and then I did some settings in CleanFlight. Because...

can't get my eb 185 to arm its bound to controller.when i push down right nothing happens apart from a lot of beeping from the quad.

Using Flysky's AFHDS 2A protocol with older Flysky FS-i6 and new Flysky X6B i-Bus, PPM, PWM receiver set up for PPM. Receiver bound. The receiver controls are operational under Betaflight 3.0.1. Escs are calibrated. Channel 5 is mapped to AUX 1 for arming. Under Betaflight, I can see switching...

Bio: Went through youtube university to learn how to build a quad due to interest and absolutely noting to do in Odessa TX...seriously if dirt doesn't give you a boner don't come here... Watched to many RotorRiot videos and had to buy their gear... Now I've gotten myself in $$$ deep and have...