Search results

Do you mean to say that the FS i6s transmitter is not compatible with the Redcon receiver? I do own a multimeter, not sure how that will help in this case.

I can't bind my fs i6s transmitter to Redcon cm703 receiver. I have spent most of today trying, I insert the bind plug in the receiver, plug in 5 volt from BEC. Receiver light flashers fast. Turn on the transmitter, select model2, goto bind RX. Wait for about a minute, and the ligh...

This being my first build I have no idea what is a good or bad motor, so I am open to recommendations. The motors I am using are Chinese A2212/13T 1000KV and the esc's are Readytosky ESC-30A DC:5.5V-12.6V BEC 5/2A Are these parts "nice"

Thanks for your reply, I am building the copter from a kit. What I did was to exchange channels, I put no 3 motor (the suspect one) into no 4 position on the flight controller. I hope I am not wrong but I think one of the motors (no. 3 the suspect motor) may have developed a short and taken...

On my first flight I found that on shutting down, one of the motors stopped noticeably quicker than the other three. I never got much off the ground as the quadcopter wanted to flip. after a few hours I thought I would Check the prop rotation ( which was ok) but found the suspect motor (3)...

I read that it's normal for the motors to run slow when armed with V3.2.1 So there was nothing wrong. Seems like a good idea.

I found V3.2.1 and downloaded and installed it. Set up the board again. I calibrated the esc's one at a time with the receiver, they run great as expected via receiver. Connect the esc's to the APM and run the motors. They run as described in my first post. When I armed the board the motors...

Thanks for your reply, when I go to download V3.2.1. I get a message, that version is retired. I will try and download again .

It seems that APM 2.6 is no longer supported by copter, or is it. what can we make of this??? APM 2.5 Warning The APM2.6 board is no longer supported for Copter. From Copter 3.3 firmware (and later) no longer fits on APM boards. The last firmware builds that can be installed (AC v3.2.1) can be...

Thank you for your reply, I thought I did that, I calibrated the esc's manually one at a time and when they run they sound like they are all running at the same speed. I am not sure about the flight controller, I re calibrated that with mission planner, going through each stage. I will try and...

Hi all, I am a new member to this forum and this is my first post. I am building a F450 quadcopter. Using an apm 2.6 FC . I set it up as per painless360 YouTube videos . Using mission planner. I did have it setup correct at one stage, where I was able to arm the board and throttle the motors...