Fuzzy Integrated OSD and Video..

Jay Rosenthal

New Member

• Jul 20, 2017

• #1

I need help.

More detail of the build is in the comments section of the first video. Joshua Bardwell is super busy and cannot help me.
Any suggestions.would be much appreciated

 

yay

Well-Known Member

• Jul 20, 2017

• #2

try another vtx or monitor to isolate the issue. i'm new to this ...... maybe interference? as bad in another location?

 

Jackson

USA member at large

• Jul 20, 2017

• #3

https://www.rcgroups.com/forums/showthread.php?2736482-Terrible-lines-and-jitter-on-FPV-video-signal

 

Jay Rosenthal

New Member

• Jul 20, 2017

• #4

Yea I have capacitors on the way. I already replaced the camera. Ordering a new vtx and dedicated fpv goggles. If that doesn't fix it I'm done with this $300 waste lol. There's always los

 

GrannyApple

Member

• Aug 2, 2017

• #5

Try hooking the camera gnd, osd gnd, and vtx gnd all to one common ground on your pdb.

 

RENOV8R

Well-Known Member

• Aug 2, 2017

• #6

Are your RX & TX antennae compatible? Other than what's already been suggested, make sure the screws that fasten your motors on are the proper length. Too long and making contact with the stator can cause this issue.