I am unable to get my radio to indicate any communication to the FCB ( naze 32) while on Baseflight. moving the throttle forward and back gets no movement of the colored bar at the throttle. The problem may be that I have the RX cables out of order on the FCB but I think they are right. I need something to check the sequence at the FCB. Is the throttle on the far left or right? BY the way I had a successful bind after a couple tries but I have reconfigured the Radio (DX6) settings since then and can't get a new bind yet.
Also I have a motor that is acting funny. Sometimes it clicks and jerks as I bring the rpm up using my mouse in Baseflight. Just one motor(motor #1) does this and it ceases this event after a number of throttle runs, again using the mouse in Baseflight as my radio doesn't seem to want to talk to the FCB yet. All the motors all seem to start at about 1073rpms as indicated in baseflight. I haven't switched it with the opposite motor to see if it does it on the other ESC but will attempt that tomorrow.
THank you...
Also I have a motor that is acting funny. Sometimes it clicks and jerks as I bring the rpm up using my mouse in Baseflight. Just one motor(motor #1) does this and it ceases this event after a number of throttle runs, again using the mouse in Baseflight as my radio doesn't seem to want to talk to the FCB yet. All the motors all seem to start at about 1073rpms as indicated in baseflight. I haven't switched it with the opposite motor to see if it does it on the other ESC but will attempt that tomorrow.
THank you...