FPV Feed cut out problems

S

Signori

Member
Hi all,

Anyone know why my feed cuts out after only about 5-10 meters away? I'm not very technical minded, i just enjoy flying it :). The company most of the specs are from put it together for me.

Quad specs are:
ZMR 250 frame
Emax 2204 motors (2300kv)
FlySky FS-i6 6CH Transmitter + iA6B 2.4GHz 6CH Receiver with Telemetry
Boscam TS5823 5.8GHz 32CH A/V 200mW Mini FPV TransmitterBoscam RC305 5.8Ghz 8 Channel AV Receiver for FPV
Quanum DIY FPV Goggles V2 w/5 inch LCD Monitor (Kit)
FunFly Acro Naze 32 Flight Control Board
CC1333-B Board Camera Sony Super HAD CCD with 600TVL (IR Blocked CC1333)
ImmersionRC SpiroNET Omni 5.8GHz RHCP Antenna (SMA)

Any help would be great,

Thanks
 
Last edited:
S

Signori

Member
They just called me back and it seems it might be working as it should now. When it stops raining i'll give it a test flight and report back.
 
S

Signori

Member
Wow forgot to reply, sorry :( Well my initial problem was just the channels not matched to the receiver...ooops:(

Anyway, so i've been practicing flying fpv quite a bit over the last couple of weeks. And just now i was flying, all was going great. Onto my 2nd battery and after about 3 minutes my video feed starts flickering really badly, managed to bring the quad down in time and then the feed just stopped completely.
Any ideas what might have caused this to happen? The feed doesn't flicker any more its just a fuzzy screen now. I've tried a different channel and just get a fuzzy screen, also i hadn't crashed at any point today either.

Thanks guys
 
Wildwelder

Wildwelder

Well-Known Member
Check the integrity of your video wire from the fpv camera and its connection. Fpv quads can take a beating from crashes and some things loosen up. I've had the same prob. Nothing worse than losing tx feed with goggles on.
 
You must log in or register to reply here.
Top