Recent content by Technut

Hell, it was free

I singed up right af term the site came up. No big deal and alot cheaper than paying a fine. Bought a Dymo lable maker and printed out copies for all my quads. Just no big deal!

Has anyone tried the 3 blade props on their 200qx and liked them? They just don't seem to hold like the 2 blade props. Also seem to lose altitude very fast when doing manuvers. Just wondered if anyone else had experienced this.

Hello, I'm from Alabama and got started in May of 14. I am totally hooked on this sport! Started with helis but quadcopters are so much fun to fly I have shelved them for now.

I loaded the ver3 firmware in my qx2 and qx3 and now cannot activate rth. I am using a dx6i and have updated settings as per vids on HH network. I know someone out there may have the same problem and can help. TY in advance!!!

HELLO,will a Devo tx work on a Blade 350qx or a 200qx? . Read somewhere this would work.

Is your RTH switch activated?

I did find out that you have to change tx settings for the version 3 download. This also changes wich switch activates RTH. Ss if you have a 350qx and download V3 make sure to change tx settings!

loaded v3 in my 350qx. Now I have to raise the throttle almost halfway to get motors spinning fast to take off. once flying it seems to work properly. im using a DX6i. any help would be apreciated

Wish I had $499.....love to have one!

The motors are not connected. With battery connected and switch on, after a few seconds the Esc's are almost too hot to handle.

I checked out my Esc's last night and found 3 to get so hot it would burn you. Didn't see any bad connections or loose solder. There was discoloration on bottoms of the 3 escs. Is there anyone who can repair these? It's probably cheaper to just replace them.

Will do!

TY I just might do that if I don't resolve the problem myself

That's what I was thinking! TY Holtneil for the backup.....