Recent content by Robert Bray

It's sorted! 5hours of work but have it. It was a problem with a plastic insert that the rotor screw into. It had worn away. Swapped it and it's perfect!

Hi, thought this deserves a new thread as I want to explain the history. Firstly I posted regarding a problem with backwards mode on the x5sc. You showed me how to fix that but then shortly after the drone stopped giving me lift. I replaced a suspect motor and it gave me lift and direction...

Hi they are all spinning correct directions and blades are installed as per the pictures. I don't understand it. It worked while secured temporarily with tape after I changed the motors but then I removed tapes, put screws back in and turned back on and now it won't fly.

And by same problem I mean it won't lift off. I sorted the backwards forwards issue during my 2 minute flight! Thanks for that too. Now it won't lift. Bodes correct and spinning correct directions

Ok so new motors and gears arrived also I changed out the suspect motor and gear first! Worked a treat for 2 minutes. Placed landing gears and screws back in. Fired it up again and it's the same problem! What the hell! Swapped out rest of motors and still the same! Help!!!

Hi can you tell me how you centred your trims on the x5sc? Thanks

Yeah I've tried on a very level surface and it's still the same. It was my first drone so inevitably it has taken quite a few knocks! It doesn't have any major damage to it though. I've ordered new gears and motors and I'll swap them out to see if it helps, but starting to think it may be...

have a problem with my x5sc, it will fly forward very fast but when I pull back on the stick its coming back to me very slowly, I have to have the trim all way back to stop it flying forward on its own. I have done the calibration but this makes no difference. its only a week old as well. should...

Hi did you find a solution to this problem? I have the exact same issue and it doesn't seem to be a common fault online.