Recent content by johnathan

I was really hoping it would be fine.. I wrapped it in electrical tape.. against your advice.. imma have to keep it /: its my inly one. When I buy a replacement arm ill get a replacement battery too. My x8r end antenna piece broke off. The plastic piece at the end, one of them broke off. Do you...

The first fee flights /crashes have beat up my only battery pretty bad, the crack in the packaging kinda worries me, it still charges and works. But, do yall think this crack will eventually, maybe, explode?

https://m.facebook.com/story.php?story_fbid=1171391242885581&id=100000441500559&ref=bookmarks this is my facebook post where I shared the video. Gah lol. I believe my mistake was giving it too much pitch and not enough throttle... I will be sure to not make the same mistake again.. I hope

I hit a fence post goes really fast lol

My brother recorded my fail..

You will be missed.. gah

Omg its glorious

Nvm I figured it out. Thabk you everyone

Where can I get a download link for a libre fireware so I can manually flash it?

Now libre is giving me about the same message... pribably bc I flashed the open pilot to it. Gah, whats a uploader plugin??

Your link didnt work. I couldnt find libre pilot, I was able to get everything ti working.. but.. now it wont fly, some motors turn sometimes other times they dont. It just flops on its belly when I try to fly it..

I did

Fixed that part too.. I had to connect the battery again, I habe a problem now, I set the x8r up to the cc3d using sbus. I have my transmitter and receiver paired, but my transmitter wint work the.motos, on the openpilot gsc program when I calibrate the controller it doesn't recognise my inputs...

Well I got past that. Now im on the esc calibration procedure, and im suppose to hook the battery up and wait fir the beeps then disconnect the battery, but when I connect the battery, they all keep beeping and wont stop, I finished the step without it finishing then the bext step to find the...

Gsc is the program I use right? Open pilot gsc? I fet this error, how do I correct this..