GlassKnees's Recent Activity

  1. GlassKnees posted a new thread.

    Merry Christmas All!

    [IMG]

    Forum: General Discussion

    Dec 10, 2018 at 3:42 PM
  2. GlassKnees replied to the thread Planning A New Build.

    Uh, sorry if I didn't indicate that I am using 40 A ESCs. The Motors can draw up to 38 A at full power but I don't intend to run them...

    Dec 8, 2018 at 10:19 PM
  3. GlassKnees replied to the thread Planning A New Build.

    Well, first flight ended in failure. After arming, I started to advance the throttle and the aircraft immediately toppled onto its left...

    Dec 8, 2018 at 1:42 AM
  4. GlassKnees replied to the thread Planning A New Build.

    I have good news! I solved my arming problem - turns out that the ESCs are okay after all. I successfully calibrated each ESC...

    Dec 7, 2018 at 9:20 PM
  5. GlassKnees replied to the thread Planning A New Build.

    Yeah, I saw that in the specs, but the T-Motor site also shows 40 A ESCs with this motor:...

    Dec 6, 2018 at 12:03 AM
  6. GlassKnees replied to the thread Planning A New Build.

    Short note: ESC calibration failed as well as my attempt to arm the aircraft. Mission Planner offered no clue as to the problem. I...

    Dec 5, 2018 at 3:28 AM
  7. GlassKnees replied to the thread Planning A New Build.

    Software configurations are complete. I managed to solder on an EC5 plug onto my lipo - powered up the aircraft using it and...

    Dec 4, 2018 at 5:51 PM
  8. GlassKnees replied to the thread Planning A New Build.

    My propellers arrived! Here it is - completed: [IMG] Here are my two quads side by side: [IMG] I still have some software...

    Dec 3, 2018