Recent content by FMusso91

Hi Wafflejock, thanks for the encouragment! I need it as I am a little off recently.. I have re-checked the motors and the rotation is correct. To check the trust-weight, I have tried to fly the drone without the battery on the frame, but instead I placed the battery on a closed elevated...

Hi Dugdog, Wafflejock, Sorry for the late reply, I have tried a couple of things before writing back. I have tried the manouvers suggested above but the drone wouldn't death roll or flip. The battery is a Lipo 11.1v 3S 2200mAh 50C with XT60 Plug (YOWOO) and the total drone's weigth is <600gr...

Hi Dugdog, Wafflejock, Many thanks for your support, it's great to count on this great community! In the past days, I have tried to fly... but the drone is not lifting off o_O! The motor are correctly spinning and accelerating, so maybe it is the weight/trust ratio? Not sure if I should open...

Hi guys, good and bad news.. The good is that, following your advices, I have fixed the ECS signal wires and I was able to calibrate the ECSes using the PWM (via Betaflight as per video above). Now, in the "Motor" tab of Betaflight, I am able to spin each motor using the corresponding levers...

Thank you guys (also to C3P0 ahahah)! I have just tried using the PWM protocol but the result is the same. So as you suggest, it must be the signal wire, I will re-check it and try re-soldering it directly to the FC. Talking about protocols, the ESC (Chaos) should support the Dshot1200 with...

Hi Wafflejock! First, thank you for taking the pain to read all of this and replying.. I may have insert too much information, but better than too less ;) So, I have recorded a short video where I plug-in the battery to record the ECS bipping and here the link Plug in of the battery - does...

Nobody? Please guys, I don't know what to try next..

Hi all! I am a beginner, building my first quadcopter and I am seeking for help to resolve an issue that I am really struggling to resolve. The drone is assembled, but I am unable to spin up the motors (both using the transmitter and in the motors tab in Betaflight) nor to read and flash the...