Recent content by cookie1985

  1. cookie1985

    X8 Octo Setup

    Hi Everybody, Does anyone have any experience with the 4 - 1 esc brains?" http://www.ebay.com/itm/271648206601 It wont be that specific one, but i was going to use two of them rather than 8 x esc for x8 config? My reasoning was to cut down on alot of wiring. I am exploring the idea of 18650...
  2. cookie1985

    First Build flips on takeoff

    I will weigh tonight
  3. cookie1985

    First Build flips on takeoff

    My reciever is plugged in through sbus, when i went through the cc3d wizard, it assigned it automatically
  4. cookie1985

    Flips on take off, cc3d help

    Thanks andy, will let you know how i go
  5. cookie1985

    Flips on take off, cc3d help

    Hey Jackson, Yes I have checked those.
  6. cookie1985

    Open Pilot ??

  7. cookie1985

    Open Pilot ??

    You can change the module on your radio, you have to open up the panel above the audio jack you mention.
  8. cookie1985

    Open Pilot ??

    Kim, Yes, with UHF it does extent the range considerably. Most transmitters have a module bay at the back that you can added additional external antennas. A few examples is if you are using a reciever that is a different brand to your transmitter. You can buy a module that is compatible...
  9. cookie1985

    Open Pilot ??

    What are you trying to do?
  10. cookie1985

    Anyone know the basic wire setup for a CC3D to a FrSKY X8R receiver?

    Yeah mine did it when lipos were low, i was running a 1000 test battery, so i noticed it, i also found that the receiver went into standby (best way) to describe, might be the same thing, i noticed this when i was testing props via cc3d. I would then have to touch controls, then it would come...
  11. cookie1985

    Anyone know the basic wire setup for a CC3D to a FrSKY X8R receiver?

    Mine does the same, i am not sure if it struggles when the lipo is running low. I have seen on youtube there is ways of also calibrating the range on the taranis, but i am not sure the practical benefits of this... Let me know how you go fine tuning the settings...
  12. cookie1985

    Anyone know the basic wire setup for a CC3D to a FrSKY X8R receiver?

    Needs to be binded on D16 on taranis, you will need the bind plug and jumper from memory
  13. cookie1985

    Anyone know the basic wire setup for a CC3D to a FrSKY X8R receiver?

    Plug the lipo in? Mine doesnt turn on without the battery
  14. cookie1985

    Anyone know the basic wire setup for a CC3D to a FrSKY X8R receiver?

    I left it. Main port: s.bus Flexi: gps
Top