Recent content by baevans11

I did that but thx for the suggestion.

I just switched to Taranis x9d plus and I put a rxsr on my chameleon. I jumped the 5v jumper and wired the rxsr on the same uart my lemonrx was on. I set up the model in my taranis and changed the tab in configurator to sbus, I also still have the serial rx on uart 2. I changed the channel map...

No there isn't a bind plug as it's a dime sized satellite type rx. But I figured it out. You have to go into Betaflight and do the configuration first then go through the bind process.

I have the furious fpv acrowhoop v2 spektrum version and it won't go into bind mode. I tried going into cli and typing set spektrum_sat_bind=9 then enter then type save then enter. I unplug then plug back in and the orange led on rx never comes on I tried binding anyways and no luck I even tried...

Ok thx. Yeah armatton said that the betaflight f3 controller is compatible with a sat rx. I just wanted to be sure I was putting the best rx option.

What us the difference between the lemon rx and sat rx? Is it merely the range? If so what's the range difference? This is for a 250 size quad build.

Ok that's what I thought thx. Just wanted to be sure.

So if I buy the Fatshark dominator v3 goggles and the antennas do I need to buy the receiver module as well? I have the immersion tramp vtx for my drone build. This is my first drone build so I'd appreciate any guidance. Thx.

I'm building my first drone my parts list are as follows: Chameleon frame, Betaflight F3 flight controller, Armatton velvet motors & 30a escs, runcam eagle camera, lemon satellite rx, Immersion tramp HV vtx and I plan to get the Fatshark V3 Dominator goggles. My first ? is do I configure the F3...

I am building my first quad and I have almost all the parts picked out but I have some questions. My parts I've picked out are as follows: Aramatton Chameleon frame, Betaflight F3 flight controller, oomph velvet motors, Aramatton's 30a escs, lemon rx (I'm waiting on a response from Armatton as...