Thanks, I've just found out that my 5v output from the pcb is dead so that's why it would only arm when connected to the computer.
Thank's for your help
I've tried :
1. if the Quad is not level
2. CPU Load too high
3. Receiver end points / binding
4. Receiver channel to function binds set min_check = 1005 (for a throttle that bottoms out at 1000)
and it's not one of these problems
rxfail 13 h
rxfail 14 h
rxfail 15 h
rxfail 16 h
rxfail 17 h
set align_gyro = DEFAULT
set gyro_lpf = OFF
set gyro_sync_denom = 2
set gyro_lowpass_type = PT1
set gyro_lowpass_hz = 90
set gyro_notch1_hz = 400
set gyro_notch1_cutoff = 300
set gyro_notch2_hz = 200
set gyro_notch2_cutoff = 100
set...
Hi, I can't arm my drone, I've tried lots of things but still doesn't work.
I've got an SPRacing F3 flight controller
when I go in the CLI and type status it says : "Arming disable flags: 0x88" or "Arming disable flags: 0x89" or "Arming disable flags: 0x81"