have a syma x8g quad in which I had to replace both upper and lower body on. I thought I was pretty sure I transferred everything over from the old one to the new one in the same order as I took them off of the old new. After I got it put together I noticed that once it lifted off that the thing restated while it was in flight. Did I overlook anything?
Weird!!!
- Thread starter Garyp
- Start date
OK I just took it apart again check the antenna it's straight not bent so I put it back together turned it on and what it's doing is when you give it throttle it goes up-and-down fine and you can control it but the drone itself sits and just completely spent and 360° what's up with that
I just got done checking them and everything checks out just as you say it should be in you're drawing. Here's the thing, I can set it on the table, give it a little throttle and it sits there fine... I go to pick it up and the thing acts like there's a short in it like the motors are alternating back and fourth every
RENOV8R
Well-Known Member
It's supposed to do that. What you're seeing is the motors compensating for the change in angle. The gyro wants the quad to be level, so when you tilt it, its thrusting the motors on the low side to try and get it back to level. In fact, it appears to be functioning properly
Jackson
USA member at large
Did you double check the props and rotation per my pic? Well?
RENOV8R
Well-Known Member
Yes
Fly crash repair repeat
Member
Hi, Sounds like you're in headless mode.. There's acro mode, level mode and headless mode, headless mode will fly in the direction you send it but it will not have a front or back.. Ken
Jackson
USA member at large
No there isn't.
Fly crash repair repeat
Member
There won't be acro on this kind of drone, I was just listing the types of modes for his research, amigo..